Setup

01

Use the hangers.

1. 1

   Match the labels: each crossbar and stem is marked with its holder type, like PSA. Pair a crossbar and a stem with the same label.

   
2. 2

   Slide the crossbar's middle block sideways into the slot at the top of the stem. It's a snug fit, so give it a firm push.

   
3. 3

   Graded slab: tilt it and seat its bottom edge in the stem's bottom hook, then stand it upright against the hanger.

   
4. 4

   Graded slab: gently push each side hook outward. The crossbar has a little give, so the hooks open just enough to come around the slab's edges. Let go and they close around it, holding it securely.

   

1. 5

   Toploader or One-Touch: no tilt. Slide it straight down between the side hooks until it rests in the bottom hook.

   
2. 6

   Lay the display face up on a table, unlock the front and open it like a book. Line up the stem with a hole in the back panel: the magnet in the stem holds it to the metal plate. Close and lock the front.

   
3. 7

   To take a card out, lift the hanger off the back panel. Graded slab: gently push the side hooks out, tip the top forward and lift it out of the bottom hook. Toploader or One-Touch: slide it straight up.

Back to top

02

Set up the stand.

1. 1

   Find the two stand pieces. The base has its slot at the top; the top piece has its slot at the bottom.

   
2. 2

   Stand the base upright. Hold the top piece across it at a right angle, line up the two slots and slide it straight down until both pieces sit flat.

   
3. 3

   Optional: for extra hold, screw the two small brackets into the corner where the pieces meet, one near the top and one near the bottom, using the four included screws and a Phillips screwdriver.

   
4. 4

   Place the display on the stand as shown.

   
5. 5

   For stability, don't change cards while the display is on the stand. Lift it off, lay it face up on a flat surface and open the front, then swap cards. On the wall, you can swap them in place.

   

Back to top

03

Hang it on the wall.

1. 1

   Measure the distance between the centers of the two keyhole brackets on the back of the display.

   
2. 2

   On the wall, mark two level points that same distance apart. Drive in the two included 1-inch screws about three-quarters of the way, leaving about ¼ inch out.

   Good to know: we've tested the included screws to hold the full weight of the display in standard drywall. For a more secure fit, use drywall anchors (not included).

   
3. 3

   Hook the keyholes over the screw heads and let the display slide down onto them. It hangs flush and level.

   

Back to top